• +90 212 702 00 00
  • +90 532 281 01 42
  • I info@muayene.co
trarbgzh-TWenfrkadefaru

LVD Enclosure Strength Test

Enclosure resistance tests of electrical and electronic devices are carried out according to TS EN 60079 standard. Since this standard is a standard of general requirements, multiple tests are carried out concerning the type of protection. Tests such as reference pressure tests, hydrostatic overpressure tests, maximum surface temperature detection, thermal shock tests, thermal shock tests, mechanical impact resistance tests and surface resistance tests of non-metallic materials are carried out.

This TS EN 60079 standard series consists of:

  • TS EN 60079-0 Explosive gas atmospheres - Part 0: Equipment - General requirements
  • TS EN 60079-2 ... Section 2: Devices protected by pressurized enclosures “P”
  • TS EN 60079-5 ... Chapter 5: Powder filling devices protected by “Q“
  • TS EN 60079-7 ... Part 7: Increased safety Hardware protection with “E”
  • TS EN 60079-11 ... 11 - “I” type self-protected devices
  • TS EN 60079-15 ... Section 15: Protection of equipment with “N” type protection
  • TS EN 60079-17 ... Section 17: Inspection and maintenance of electrical installations
  • TS EN 60079-18 ... Section 18: Protection of equipment by encapsulation of the “M” type
  • TS EN 60079-19 ... Section 19: Repair, major maintenance and commissioning
  • TS EN 60079-26 ... Section 26: Equipment with device protection level (EPL) Ga
  • TS EN 60079-28 ... Section 28: Protection of equipment and transmission systems using optical radiation
  • TS EN 60079-31 ... Section 31: Equipment protected against dust ignition by “T” type housing

Numerous electrical tests in authorized laboratories enclosure strength tests are also performed. our organization in the scope of LVD testingConducts LVD enclosure resistance tests in accordance with relevant regulations, standards and test methods developed by national and international organizations.

In addition, our organization, ÖSAS Accreditation Agency, It is accredited according to TS EN ISO / IEC 17025 standard and the tests, measurement, analysis, inspection and inspection procedures and reports are accepted as valid in private and official audits.