• +90 212 702 00 00
  • +90 532 281 01 42
  • I info@muayene.co
trarbgzh-TWenfrkadefaru

Examination

  • Examination

The frying wire test method is generally applied on the plastics holding the parts carrying the electric current. During this test, the plastic material is contacted with the wire heated at high temperatures and after a while it is observed how the plastic material is affected by this contact. In the meantime, if the flame occurs after contact, the extinction time and the presence of dripping in the plastic part are examined. In short, this test ensures that the plastic material does not burn at certain temperatures. In general, the standard used in this test is:

  • TS 10486 EN 60998-1 Connecting devices (terminals) - for low voltage circuits in the home and similar areas - Part 1: General specifications

This standard specifies that solid or braided rigid or flexible, cross-sectional area from 0,2 square millimeters to 35 square millimeters, where electrical energy is used in residential and commercial buildings, in the form of independent units for the connection of two or more copper conductors, with a rated voltage of 1000 Hz up to 1000 volts. alternating current and 1500 volt direct current.

This standard is a test standard used in electrical applications in general and as a result of the tests the strength of the plastic material in high temperature or induction environment is measured.

In addition to this standard for glow-wire testing, the following standard is also applied:

  • TS EN 60695-2-11 Fire hazard test - Part 2-11: Test methods based on glow / hot wire - Glow-wire flammability test method for final products (GWEPT)

Glow wire tests are applied to calculate the risk of flammability and self-extinguishing capacity of the plastic material used in electrical devices.

Numerous electrical tests in authorized laboratories blushing wire tests are also performed. our organization in the scope of LVD testingConducts LVD glow wire tests in accordance with the relevant regulations, standards and test methods published by domestic and foreign organizations.

In the meantime, our organization, ÖSAS Accreditation Agency, It is accredited according to TS EN ISO / IEC 17025 standard and the tests, measurement, analysis, inspection and inspection procedures and reports are accepted as valid in private and official audits.